Investigation of titanium liquid/gas diffusion layers in proton exchange membrane electrolyzer cells

In a proton exchange membrane electrolyzer cell (PEMEC), liquid/gas diffusion layer (LGDL) is expected to transport electrons, heat, and reactants/products to and from the catalyst layer with minimum voltage, current, thermal, interfacial, and fluidic losses. In addition, carbon materials, which are typically used in PEM fuel cells (PEMFCs), are unsuitable in PEMECs due to the high ohmic potential and highly oxidative environment of the oxygen electrode. In this study, a set of titanium gas diffusion layers with different thicknesses and porosities are designed and examined coupled with the development of a robust titanium bipolar plate. It has been found that the performance of electrolyzer improves along with a decrease in thickness or porosity of the anode LGDL of titanium woven meshes. The ohmic resistance of anode LGDL and contact resistance between anode LGDL and the anode catalyst play dominant roles in electrolyzer performance, and better performance can be obtained by reducing ohmic resistance. Thin titanium LGDLs with straight-through pores and optimal pore morphologies are recommended for the future developments of low-cost LGDLs with minimum ohmic/transport losses.     

二维平流扩散模型下的集合卡尔曼滤波模拟同化研究

为提高环境数值预报水平,构建了一个针对污染物扩散的模拟数据同化系统。采用集合卡尔曼滤波方法对二维平流扩散模型的状态变量进行了实时校正,实现污染物浓度的实时模拟预报,完成了敏感性实验中集合数目变化、观测方差变化和同化窗口长度变化研究。比较考察观测点位置与污染源距离不同时的预报效果,探讨了优化条件下的同化策略,提出一种根据距离远近动态调节卡尔曼增益权重的方法。在集合数目较小时,可降低计算代价,得到优化的同化效果。     

氢安全研究现状及面临的挑战

氢能具有储运便捷、来源多样、洁净环保等突出优点,许多国家把发展氢能作为重要的能源战略。氢安全是氢能大规模商业化应用的重要保障。在分析国内外氢安全领域近年来最新研究进展的基础上,依次从氢泄漏与扩散、氢燃烧与爆炸、氢与金属材料相容性及氢风险评价等方面,系统总结了国内外氢安全研究面临的挑战,并对我国氢安全的发展提出了建议。     

大气污染排放窗口机制研究

以2种典型的污染排放源(点污染源和线污染源)为基础,提出排污窗口的概念,通过参数转换分解源强对污染扩散进行研究。首先在高斯污染扩散模型的基础上,对非持续性污染源强建模,然后以某烟囱的周期性排污分析,检验排污窗口设置的合理性。对于单双号限行的窗口性质的污染排放研究中,首先对交通流建立线污染扩散模型,然后融合元胞自动机(9元胞互影响)模拟区域多角度污染的扩散平衡,最后对"单双号限行"下北京市不同区域空气质量指标进行分析与仿真。分析结果表明,合理的排污窗口能够减轻污染程度及对人们日常生活的影响。     

Case study of landfill leachate recirculation using small-diameter vertical wells

A case study of landfill liquids addition using small diameter (5 cm) vertical wells is reported. More than 25,000 m³ of leachate was added via 134 vertical wells installed 3 m, 12 m, and 18 m deep over five years in a landfill in Florida, US. Liquids addition performance (flow rate per unit screen length per unit liquid head) ranged from 5.6 × 10^?8 to 3.6 × 10^?6 m³ s^?1 per m screen length per m liquid head. The estimated radial hydraulic conductivity ranged from 3.5 × 10^?6 to 4.2 × 10^?4 m s^?1. The extent of lateral moisture movement ranged from 8 to 10 m based on the responses of moisture sensors installed around vertical well clusters, and surface seeps were found to limit the achievable liquids addition rates, despite the use of concrete collars under a pressurized liquids addition scenario. The average moisture content before (51 samples) and after (272 samples) the recirculation experiments were 23% (wet weight basis) and 45% (wet weight basis), respectively, and biochemical methane potential measurements of excavated waste indicated significant (p < 0.025) decomposition.     

At home and abroad: An empirical analysis of innovation and diffusion in energy technologies

This paper contributes to the induced innovation literature by extending the analysis of supply and demand determinants of innovation in energy technologies to account for international knowledge flows and spillovers. We select a sample of 38 innovating countries and study how knowledge related to energy-efficient and environmentally friendly technologies flows across geographical and technological space. We demonstrate that higher geographical and technological distances are associated with lower probabilities of knowledge flow. Next, we use previous estimates to construct internal and external knowledge stocks for a panel of 17 countries. We then present an econometric analysis of the supply and demand determinants of innovation accounting for international knowledge spillovers. Our results confirm the role of demand-pull effects, proxied by energy prices, and of technological opportunity, proxied by the knowledge stocks. Our results show that spillovers between countries have a significant positive impact on further innovation in energy-efficient and environmentally friendly technologies.     

Ti/SnO_2-Sb阳极-空气阴极电催化降解染料废水

为解决电化学法处理高盐染料废水存在的能耗大、成本高等问题,分别采用溶胶-凝胶法和辊压法制备Ti/SnO_2-Sb阳极和空气阴极,构建了Ti/SnO_2-Sb阳极-空气阴极双极体系(TSSA-ADC)。甲基橙(MO)作为高盐染料废水的典型污染物,考察了电流强度、MO浓度、电解液浓度和初始p H对TSSA-ADC体系和TSSA单阳极体系降解MO的影响。结果表明:与TSSA单阳极体系相比,TSSA-ADC体系具有更好的抗有机负荷冲击、抗盐分冲击、抗酸碱波动能力,能够维护酸碱平衡防止硬度离子结垢。最佳反应条件为电流强度为0.030 A,电解液浓度为3%,MO浓度为100 mg/L,初始pH=6。以MO去除率达到98%为基准,TSSA-ADC体系比TSSA体系可节能74.26%。     

山区和平原连接处SF6试验及扩散规律研究

为更好了解污染物在复杂地形条件下的湍流扩散规律,2010年9月开展了一系列SF6示踪扩散试验,获取了SF6浓度数据,以此实验数据为基础,计算出SF6浓度分布在水平和垂直方向的扩散标准差、地面峰值浓度等参数,并与P-T-C扩散参数进行对比,总结得出了污染物在山区和平原连接处中性、稳定、强稳定等气象条件下湍流扩散规律。     

街区建筑物对城市交通隧道废气排放的影响

采用大气边界层模式和随机游动扩散模式相连接的模拟方法,对上海市拟建的交通隧道排气口附近街道建筑物区域的气流分布和废气排放物浓度场进行了数值模拟分析,设计了6种方案,并按不同的废气排放形式,分别分析了街区的地面污染物质量浓度分布.结果表明,在建筑物存在的情况下,排风口造成的地面污染物质量浓度的最高值会很大,可达0.44 mg/m3,若换成排风塔,则为0.13 mg/m3; 没有建筑物的情况下,由排风口和排风塔造成的地面污染物最高质量浓度分别为0.11 mg/m3,0.4 mg/m3.当风速增大,质量浓度会降低,最大值分别从0.44 mg/m3降为0.2 mg/m3,和从0.13 mg/m3降为0.1mg/m3.分析表明,建筑物附近的气流特征对污染物扩散会起引导作用: 垂直方向上,导致污染物从高空被带入地面; 水平方向上,使得污染物在下风向堆积; 当风速增大时,地面污染物质量浓度值降低.同时研究表明,对排风塔污染物散布起主要作用的是水平方向的气流结构,而对排风口的污染物散布起主要作用的则是其附近建筑物的背风侧的气流下洗效应和水平流场,因此建筑物背风侧有可能成为重污染区.     

Effects of long-term amendment of organic manure and nitrogen fertilizer on nitrous oxide emission in a sandy loam soil

To understand the effects of long-term amendment of organic manure and N fertilizer on N2O emission in the North China Plain, a laboratory incubation at different temperatures and soil moistures were carried out using soils treated with organic manure （OM）, half organic manure plus half fertilizer N （HOM）, fertilizer NPK （NPK）, fertilizer NP （NP）, fertilizer NK （NK）, fertilizer PK （NK） and control （CK） since 1989. Cumulative N2O emission in OM soil during the 17 d incubation period was slightly higher than in NPK soil under optimum nitrification conditions （25℃ and 60% water-filled pore space, WFPS）, but more than twice under the optimum denitrification conditions （35℃ and 90% WFPS）. N2O produced by denitrification was 2.1-2.3 times greater than that by nitrification in OM and HOM soils, but only 1.5 times greater in NPK and NP soils. These results implied that the long-term amendment of organic manure could significantly increase the N2O emission via denitrification in OM soil as compared to NPK soil. This is quite different from field measurement between OM soil and NPK soil. Substantial inhibition of the formation of anaerobic environment for denitrification in field might result in no marked difference in N2O emission between OM and NPK soils. This is due in part to more rapid oxygen diffusion in coarse textured soils than consumption by aerobic microbes until WFPS was 75% and to low easily decomposed organic C of organic manure. This finding suggested that addition of organic manure in the tested sandy loam might be a good management option since it seldom caused a burst of N2O emission but sequestered atmospheric C and maintained efficiently applied N in soil.